Description
A complete 25 litre gas tank kit specifically designed for use on Fiat Ducato, Peugeot Boxer and Citroen Relay x250 & x290 form 2006 up to current date
For those converters who wish to install a refillable underslung LPG tank, and do not have any desire to become an expert at identifying all the different components required to complete an installation, then this Gastore Kit is for you and will provide you with almost everything from the cap on the fill point through to the regulator.
The kit also contains our unique low current, micro processor, CE approved, gas controller/display that allows the flow of gas to be controlled right from your tan
This 25 litre tank fits in the space behind the vehicles exhaust silencer and will bolt up using existing hole positions in the stronger chassis members rather than thinner floor metal. So no drilling required.
The front mounts double up with the silencer mounting brackets and the rear ones go up using the supplied nutserts. Simple !!!
The tank is then offered up and bolted to these Stainless Steel cross members.
This listing is for the under slung filler point complete with external gas BBQ outlet point.
The filler comes pre mounted on a bracket that you secure to the underside of your vehicle. Also mounted on the same bracket is a bbq outlet point with isolation.
Simply too into the gas supply going into your van and put a feed to the rear of this BBQ outlet using 8mm copper.
You can then simply connect an external BBQ or other external gas appliance using orange flexi hose.
The kit contains 3 metres of fill pipe to allow for easy routing up and over exhaust shields, through chassis members etc…
Hanging from the tank valve will be two wires 4 metres long, one for the electronic solenoid, the other to the environmentally sealed level sender.
These cables can be run up to the inside of the vehicle and connected to the supplied double fused junction box along with the 12v feed from your leisure battery.
Mount the Gastore power saver solenoid control/display in your desired position and connect to the junction box.