Description
Brand for for 2024 the Sargent K970A electric kit
Modular Power Supply Units – Provide protection and control for all AC & DC circuits
A great new design from Sargent giving a module control system allowing you to build the right electrical system for your van conversion
The EC970 is a 7″ touch screen all in one controller allow for intuitive controls of the full system
As standard will work with Lead Acid, AGM batteries – recommended total capacity 220amps
With a few upgrades you can also make them work with Lithium batteries again up to 220amp.
If you wanted to use a Lithium battery with these kits then you would need to add the below.
- Sargent DXC30-KIT 30am Dc Dc Charger
Standard kit comes with
- 1 x EC970 Touchscreen control panel
- 1 x MC200 Fully protected RCD for mains 230v
- 1 x MC100 12v fuse board with fuses
- 1 x PX300 20amp battery charger for charging leisure battery or vehicle battery
- 1 x Fresh water & waste water level sensor fit
- 1 x Environmental sensors for monitoring internal temperature / humidity and external temperature
- 1 x Mains 230v pre made harness with plus ad play connections
- 1 x 12v input pre wired harness
- 1 x 12v output pre wired harness
Optional extras
- DCX30-KIT – 30a DC-DC Charger (Only required if using Lithium batteries)
- SXC300-KIT2 – 300W MTTP Solar Regulator
Key features of each component
EC970 Touch Screen Control Panel
- 7” touchscreen LCD display
- Intuitive graphical interface
- Context sensitive help screens
- Quick install design
MC200 Mains Consumer unit
- Built-in RCD & MCB protection
- Integrated switching for heater & charger
- Reverse polarity indicator
- Plug & Play for rapid fitment
MC100 12v Control Unit
- Compact footprint – ideal for campers
- 8 x 12 volt output channels
- Dimmable lighting output
- Fresh & Waste tank inputs
- Internal & External temperature inputs
- Split charge relay for charging leisure batteries while travelling (D+ signal wire required)
- Please note split charge is only suitable for Lead Acid and AGM batteries and if you do not have a smart alternator
- If using Lithium batteries or you have a smart alternator or “Euro 6” engine you will need additional DC-DC charger and disable the split charge within the settings
Sargent PX300 230vBattery Charger
- Up to 300W 20amp charger
- Plug & play for rapid install
Specification:
Downloads:
Modular System MC100_200 + EC940 Installation User Instructions_Issue 1 (002)
